Terminal machine should pay attention to the use of matters

Fully automatic terminal machineAfter cutting off the input power, inAutomatic terminal machine Do not touch the circuit or replace parts when it shows that the charging has not subsided. The output terminals u, V, and w of the automatic terminal machine must not be connected to AC power. Note that if the automatic terminal device is installed on the control panel, please install a cooling fan to keep the ambient temperature of the automatic terminal device below 45°C. It is not allowed to carry out withstand voltage test on the fully automatic terminal. The parameters of the automatic terminal have been correctly set at the factory. If there are no other special needs, there is no need to set up from scratch.

Safety precautions: Please read this manual carefully before installation, operation, maintenance and inspection. Otherwise, only qualified personnel can carry out assembly line operations. The safety precautions in the manual are divided into "Warning" and "Caution". Note: Point out dangerous situations that may cause death or serious injury, such as negligence. Note: Indicate possible dangerous situations. If it is not cleaned, it will cause minor or minor injuries to personnel and damage to machinery and equipment. Therefore, we should read this manual carefully before using this automatic terminal. Note: Please hand this manual to the end user so that the fully automatic terminal can exert great effects. General precautions: The automatic terminal equipment has been inspected before leaving the factory. After unpacking, please check the following items in order: 1. It is the automatic terminal machine of the model you ordered. 2. Do not switch on the power supply when there is danger during transportation. 3. EachFully automatic terminal machineAll have a quality control seal. If there is no such seal, please do not connect to the power source.