How to effectively reduce the danger of operating the terminal machine?

How to effectively drop operationterminal machineRisk? span>

The safety leader has always been the theme of every production and processing company. As a terminal machine manufacturer, what should we pay attention to when operating the terminal machine to reduce the risk of operation?

First of all, workers who use terminal machines must operate under the guidance of experienced personnel, and those who do not know how to operate are prohibited from operating terminal machines privately. To use the terminal machine, be sure to familiarize yourself with the instructions for the terminal machine. Familiar with the detailed procedures of terminal machine operation.

The terminal machine is installed by designated personnel. It is necessary to manually compare whether the selected blade is matched before installing the knife. The knife can be installed after the comparison is correct. After the installation is completed, it is necessary Use hand crank test, first turn off< span style="font-size: 16px;">Terminal machinePower, press the touch button, use the special wrench to swing the master and slave wheel , Make the stamping stroke of the terminal machine to be large, if the hand does not move, consider whether the pressure is too large or other problems, and check and debug to OK. Before working, check each locking screw and confirm that there is no looseness.

When the terminal machine replaces the terminal, it is necessary to disconnect the power supply first, and then perform the replacement work. Replacement is prohibited during the operation of the machine.

After the final production is completed, arrange the good and defective products, and clean up the environment around the machine. Ensure that the next time the terminal machine is used, there will be no safety accidents caused by leftovers.

Terminal machineAs a machine used in wire processing, its position in the power industry is very important. The terminal machine can press the hardware head to the end of the wire, and then conduct the line conduction. The terminals punched out by the terminal machine are usually for the convenience of the connection of the lines, and the welding can stably connect the two wires together, and only need to be unplugged when disassembling. It greatly facilitates our use and at the same time reduces unnecessary waste. The terminal machine should be used very carefully to avoid unnecessary damage.

The above is about the relevant content of the terminal machine. I hope you will pay more attention to it. The top safety list is always our main theme.